Screen Protector
Clear display, extra protection.

Fits like a glove.
Custom-designed for X4 to fit every inch of the screen perfectly. No spot left uncovered.

Extra protection for your camera.
High-strength tempered glass that's impact and scratch-resistant. Don't worry 'bout a thing.

Take no notice.
With more than 90% light transmission, you get the same clarity and brightness from your X4. It's like it's not even there.

Easy to install.
Comes with a full Protector Application Kit for easy at-home installation. No bubbles, no hassle.

HOW TO INSTALL
Clean the screen using the screen cleaning wipe and screen cloth. Use the dust removal sticker to ensure the screen is clear of dirt.
Position the alignment tool in line with the camera screen.
Remove the film from the screen protector. Position the screen protector over the screen using the alignment tool, aligning the "Insta360" end of the screen protector with the "Insta360" end of the camera screen. Slowly move the screen towards the protector until it is covered, then remove the alignment tool. Avoid pressing down on the middle of the screen protector, as it could trap air bubbles underneath.
Scrape from the lens end of the screen protector towards the "Insta360" end until the air bubbles are completely removed.

*Notes
When removing air bubbles, scrape them from the lens end of the screen protector towards the "Insta360" end to prevent air bubbles from forming.
Do not reinstall the same screen protector. Any dust that has collected on the screen protector may cause air bubbles and reduce adhesiveness.
If the screen protector moves during installation, use the film removal stick to remove the screen protector and repeat the steps above. Do not completely remove the installed screen protector.